five. In phase fourteen, when installing the tracks (DD) towards the Wooden blocks (R), hold the wood block adhere out close to an inch previous the edge of your tracks to the side that will connect to the end piece (K and the rest). The other two blocks need to be flush with the tip of the tracks that connect to the cabinet piece.Your not too long
I created them all flush at the outset which prompted the tracks to not be extensive adequate, so the third leaf overlapped the edge of the table by about just one centimeter. Leaving that further inch (on the block sticking earlier the tracks) will help you to properly lengthen the table, insert the 3rd leaf, then drive the table shut ahead of lat
Partly of move six, I applied one of the brackets (II) to turn FF Because the mini screwdriver would not match in between the shelves. I do not believe this phase might be accomplished away from order, so you only must make owing. It a bit bent the bracket, but there should be one particular excess while in the spare areas bag. Either way, it remai
I designed all of them flush at the outset which induced the tracks not to be extensive enough, Hence the 3rd leaf overlapped the sting in the table by about one particular centimeter. Leaving that excess inch (on the block sticking previous the tracks) will allow you to effectively extend the table, incorporate the 3rd leaf, then drive the table c
I made all of them flush at the beginning which brought about the tracks not to be extensive plenty of, Hence the third leaf overlapped the edge of your table by about one particular centimeter. Leaving that added inch (of the block sticking previous the tracks) will let you adequately increase the table, insert the third leaf, then thrust the tabl